Marshall DSL40CR Combo Amplifier

Marshall DSL40CR Combo Amplifier

Tap into Marshall tone territory anywhere from your bedroom to the stage with the Marshall DSL40CR tube combo amp. With per-channel Gain and Volume controls, a dedicated Resonance control, reverb, and an effects loop, the DSL40CR is ready to gig. And with its adjustable power level, you can dial in cranked-amp tones that won't wake your neighbors — or even use the Softube speaker-emulated output for direct recording and monitoring. Marshall even refined the EQ section for extremely versatile tone shaping. From glassy cleans to bone-rattling crunch to blistering high gain, your wish is the Marshall DSL40CR's command!

Marshall's DSL40CR is an all-tube, twin-channel workhorse capable of conjuring any classic Marshall sound — past or present. Four ECC83s in the preamp section (in concert with the amp's gain/master volume arrangement) give you stunning tone-shaping mojo, and with two EL34s in the engine room, you have the volume to rule any club in the world. Sporting the same tubes (minus two EL34s) and feature set as the original DSL100, this little beast has critical upgrades that give you even more control over your sound. A Resonance control (as opposed to the original's fixed deep switch) lets you dial in your preferred amount of low-end girth. You also get studio-grade digital reverb (instead of spring), high and low power settings, and a bypassable rear-panel series effects loop. Marshall has even included a 2-way footswitch for channel switching and reverb on/off.

• 2 channels — Classic Gain and Ultra Gain
• Each channel features two modes — Clean/Crunch and OD1/OD2, respectively
• High and low power modes allow you to dial in appropriate volume for any setting
• Line output with Softube's accurate emulation of a Marshall 1960 cab
• Highly effective Resonance control replaces the original's fixed deep switch
• Refined EQ section gives you incredible tonal flexibility
• Studio-grade digital reverb
• Bypassable rear-panel series effects loop
• Included 2-way footswitch for channel switching and reverb on/off